
UK compliance guide
Manual handling: regulations, risk assessment and training
Manual handling is moving or supporting a load by hand or bodily force: lifting, lowering, pushing, pulling and carrying. Under the Manual Handling Operations Regulations 1992, employers must avoid hazardous manual handling where reasonably practicable, assess what cannot be avoided, and reduce the risk of injury. The assessment looks at the Task, Individual, Load and Environment (TILE). UK law sets no maximum weight.
Written by Thomas Featherstone TechIOSH, NEBOSH IGC-qualified and IOSH Managing Safely trained · Reviewed October 2026
What the Manual Handling Operations Regulations 1992 require
The duties come in a fixed order. Avoiding the handling always comes before assessing it, and assessing it always comes before deciding on controls.
| Duty | What it means in practice |
|---|---|
| 1. Avoid | Avoid hazardous manual handling so far as is reasonably practicable. Can the load be moved by a conveyor, pallet truck, hoist or trolley instead, or can the task be redesigned so it is not needed at all? |
| 2. Assess | Where hazardous manual handling cannot be avoided, make a suitable and sufficient assessment of the risk of injury, looking at the task, the individual, the load and the environment (TILE). |
| 3. Reduce | Reduce the risk of injury to the lowest level reasonably practicable, using what the assessment found: mechanical aids, lighter loads, better layout, team lifts, rest breaks and training. |
| 4. Inform | Give people general indications, and where reasonably practicable precise information, about the weight of each load and the heaviest side of any load whose centre of gravity is not central. |
| 5. Review | Review the assessment if there is reason to suspect it is no longer valid, or if there has been a significant change in the work. |
Employees have duties too: they must make full and proper use of any system of work the employer provides, such as using the trolley rather than carrying. Musculoskeletal disorders are one of the most common causes of work-related ill health in Great Britain, and poor manual handling is a major contributor.
How to do a manual handling risk assessment (TILE)
A manual handling risk assessment works through the factors in Schedule 1 to the Regulations, usually remembered as TILE, or TILEO with other factors added. Watch the task being done, talk to the people who do it, and note what makes it harder or riskier.
| Factor | Questions to ask | Typical controls |
|---|---|---|
| T - Task | Does it involve holding the load away from the body, twisting, stooping, reaching upwards, large vertical movement, long carrying distances, strenuous pushing or pulling, repetitive handling or too little rest? | Raise the work to waist height, cut carrying distances, use trolleys, rotate jobs, build in breaks. |
| I - Individual capability | Does it need unusual strength or height? Is anyone more at risk: a new or expectant mother, a young worker, someone with a health condition or a history of back problems? Does it need special training? | Match tasks to people, check health and pregnancy needs, provide task-specific training. |
| L - Load | Is the load heavy, bulky, unwieldy, hard to grip, unstable, likely to shift, sharp, hot or otherwise harmful? | Split into smaller loads, add handles, secure contents, label the weight and the heavy side. |
| E - Environment | Are there space constraints, uneven or slippery floors, changes in level or steps, extremes of temperature, poor lighting or strong wind? | Clear routes, improve lighting, fix floors, avoid stairs, plan outdoor work around the weather. |
| O - Other factors | Is movement restricted by PPE or clothing? Are there time pressures, piece-rate targets or poor communication between team lifters? | Choose PPE that allows movement, remove unrealistic targets, agree team-lift signals. |
For more detailed work, the HSE publishes free scoring tools: the Manual handling Assessment Charts (MAC) for lifting, carrying and team handling, RAPP for pushing and pulling, and the ART tool for repetitive tasks of the upper limbs.
A worked example
Task: receiving a weekly delivery in a small shop. This is an illustration; always assess your own tasks, loads and people.
| Activity | What the TILE review found | Controls |
|---|---|---|
| Unloading 15 kg cartons from a delivery van to a stockroom | Task: lifting from the van floor (below knee) and carrying about 20 m. Load: cartons have no handles. Environment: one step at the stockroom door. | Use a sack truck from the van tail to the stockroom; ask the supplier for cartons with hand holds; fit a small ramp over the step. |
| Placing cartons on high shelving | Task: lifting above shoulder height and reaching. Individual: shorter staff overreach. | Store heavy stock between knee and shoulder height; keep top shelves for light items; provide a stable step platform. |
| Repetitive picking during the morning delivery | Task: about 80 lifts in an hour with little recovery time. Other: pressure to clear the van quickly. | Share the job between two people, rotate with lighter tasks, remove the informal time target. |
Notice that the first control in each row changes the task or the load. Training in lifting technique comes after that, not instead of it.
Is there a maximum weight? HSE guideline weights
There is no legal maximum weight for lifting at work in the UK. The HSE’s guideline weights are a filter: below them, simple handling by most healthy adults is unlikely to need a detailed assessment; above them, it does.
- The guideline figures peak at about 25 kg for men and 16 kg for women, for a load held close to the body at around waist height.
- They are lower when the load is handled with arms extended, or at high or low levels such as above the shoulder or near the floor. If the hands pass through more than one zone during the lift, use the smallest figure.
- A more detailed assessment is needed whatever the weight if the handling is more frequent than about one lift every two minutes, or involves twisting the torso.
- The filter assumes the load is easily grasped with both hands, the working conditions are reasonable and the worker is in a stable position. The figures are not safe limits, and people at greater risk need their individual circumstances considered.
Good handling technique
The HSE’s basic principles for lifting a load. They are what manual handling training should practise, using the real loads and spaces people work with.
- Think before lifting: plan the route, check where the load is going and whether you need help or an aid.
- Keep the load close to the waist, with the heaviest side next to the body.
- Adopt a stable position, feet apart with one leg slightly forward.
- Get a good hold, hugging the load close if you can.
- Start in a good posture: a slight bend of the back, hips and knees is better than fully bending the back or deep squatting.
- Do not bend the back further while lifting, and avoid twisting or leaning sideways. Move your feet to turn.
- Keep your head up once you have hold of the load, and move smoothly rather than jerking.
- Do not lift or handle more than you can easily manage. Put the load down, then adjust its position.
Manual handling training: what the law expects
Employers must give adequate health and safety training (section 2 of the Health and Safety at Work etc. Act 1974 and regulation 13 of the Management Regulations 1999), and the manual handling assessment must take account of each person’s knowledge and training. In practice, good manual handling training:
- explains why manual handling injuries happen and how to spot risky handling;
- covers the specific tasks, loads and handling aids people actually use;
- practises good technique, ideally with a practical element on site;
- explains the systems of work in place and why employees must follow them;
- is recorded, so you can show who was trained, when and in what;
- is refreshed when the work changes, after an incident, and at a set interval.
Handling people in care settings is a specialist subject with its own training, equipment checks under LOLER for hoists, and individual handling plans for each person supported.
Manual handling FAQs
Common questions
What is manual handling?
Manual handling is transporting or supporting a load by hand or bodily force. It includes lifting, lowering, pushing, pulling, carrying and moving loads, and in health and social care it includes moving and handling people.
What are the Manual Handling Operations Regulations 1992?
They are the main UK regulations on manual handling. Employers must avoid hazardous manual handling so far as is reasonably practicable, assess the risk of any that cannot be avoided, and reduce that risk as far as is reasonably practicable. Employees must make full and proper use of any system of work their employer provides.
Is there a maximum weight a person can lift at work in the UK?
No. UK law sets no maximum weight. The HSE publishes guideline weights, which peak at about 25 kg for men and 16 kg for women for a load held close to the body at waist height, but these are a filter for deciding when a more detailed assessment is needed, not safe limits.
What does TILE stand for in manual handling?
TILE stands for Task, Individual capability, Load and Environment: the four groups of factors a manual handling risk assessment looks at. TILEO adds Other factors such as PPE, time pressure and work organisation.
Do I need a written manual handling risk assessment?
You need a suitable and sufficient assessment of any hazardous manual handling you cannot avoid. If you employ five or more people you must record the significant findings of your risk assessments. Simple, low-risk handling that is easy to explain may not need a separate detailed record.
Is manual handling training a legal requirement?
There is no standalone legal requirement for a manual handling certificate, but employers must provide adequate health and safety training, and the assessment must take account of people's knowledge and training. Training supports other controls; it is not a substitute for avoiding or reducing the risk.
How often should manual handling training be refreshed?
The law sets no fixed interval. Refresh it when the task, equipment or workplace changes, after an incident or near miss, when someone's handling technique slips, and at a set interval you decide on, which many businesses set at every one to three years.
Official sources
- HSE - Manual handling at work
- HSE - Manual handling risk filters (guideline weights)
- HSE INDG143 - Manual handling at work: a brief guide
- HSE L23 - Manual Handling Operations Regulations 1992: guidance
- Manual Handling Operations Regulations 1992
This is a plain-English summary for UK SMEs, not legal advice, and the example is illustrative. Always assess your own workplace and check current guidance on hse.gov.uk.
Train, assess and prove it
Manual handling training and TILE assessments in one place
Featherstone Safety Hub delivers the manual handling e-learning course, records who has completed it on a live training matrix, and builds manual handling risk assessments with the TILE structure, so you have a dated record of each duty. 14-day free trial, no card required to look around.
Related guides
More plain-English UK guidance
- How to do a risk assessment →The HSE's five steps, the hierarchy of controls, the types of risk assessment and a worked example.
- Construction phase plans →What a construction phase plan must contain, who writes it and when it is required.
- CDM 2015 explained →Dutyholders, their duties and when CDM 2015 applies to a project.
- RIDDOR reportable incidents →The full list of reportable injuries, diseases and dangerous occurrences, with examples.
- What is RIDDOR? →Who must report, the deadlines that apply and the records you have to keep.
- How long to keep H&S records →Retention periods for accident records, training, assessments and monitoring data.
- Hot work permits →What a hot work permit must include, the precautions checklist and fire watch timings.
- Near miss and incident reporting →Accident, incident and near miss definitions, what to record and report, and how to investigate.
Free download: a printable RIDDOR decision flowchart with the reporting deadlines, to keep with your accident book. Get the flowchart →